Top lights
Car light · footwell · Lotus Lantern · 12V DC

QAUBEN Car Footwell Lighting Kit

Two thumb-sized RGB lamps for the driver and passenger footwells, hard-wired to the car's 12V supply, that glow in any colour and flicker in time with the music.

  • Lamps2, each 4.2 × 2.1 × 1.1cm
  • Wiring2 × 150cm (4.92ft) leads
  • Power12V DC wire
  • AppLotus Lantern over Bluetooth
  • MusicBuilt-in microphone
  • HousingAluminium, IP68
Lights up
  • A soft glow at the feet that stays out of the driver's eyeline
  • Owners happy to wire into a 12V circuit for a clean, hidden install
  • Night drives with the playlist setting the colour
Pass on it for
  • Plug-and-go setups: this version runs from a DC wire, not a lighter plug
  • Lighting the whole cabin: two lamps light two footwells
  • Chasing multi-colour effects along the dash
See the glow

Two pools of colour at the driver's feet

Of every car light in the family, QAUBEN's footwell pair is the smallest way to give a cabin a mood. Two little lamps, each about the size of a thumb, tuck under the dash on the driver and passenger sides and pour colour onto the floor mats. The glow sits low, lights the space rather than the windscreen, and turns a routine night drive into something that feels like the start of a party.

Each lamp is 4.2cm long, 2.1cm wide and 1.1cm tall, holding bright 5050 RGB LEDs on an aluminium base. That base spreads heat away from the chips, so the housing stays cool enough to touch. The lamps are sealed to IP68, which matters in a footwell where wet shoes, snow and spilled coffee all end up.

  • Two lamps on a shared control line, one per front footwell.
  • Two 150cm leads, long enough to reach across most cabins.
  • 16.7 million colours, from a calm ice blue to a party magenta.
  • Short-circuit protection built into the circuit.

Because the light points down, it never competes with the road ahead. A dim, cool colour is easy on the eyes for long motorway stretches; a warm red keeps night vision intact on dark lanes. Passengers see their feet, find a dropped phone and feel the cabin wrap around them.

The kit sticks to one colour at a time across both lamps. That keeps the footwells matched, which is the tidy, factory-fitted look most drivers want.

Picture the school run on a winter morning with a soft teal under the dash, or a Friday night pick-up where the footwells glow the same pink as the playlist cover. Small lamps, big change in how the car feels.

Light specs

Every wire and watt

SpecValue
Lamps2
Lamp size4.2 × 2.1 × 1.1cm (1.65 × 0.82 × 0.43in)
Lead length2 × 150cm (4.92ft)
LED type5050 SMD RGB
Colours16.7 million
AppLotus Lantern (Bluetooth)
EffectsSteady, fade, strobe, music sync, DIY colour modes
Sound reactionBuilt-in microphone; voice control through the app
Timer and memoryYes
Voltage12V DC
Power connectionDC wire (this version)
ProtectionShort-circuit protection
HousingAluminium substrate for heat dissipation
Water ratingIP68
FitUniversal
WarrantyOne year
Model078-QA-2Foot-APP-DCWire

Bass lines that pulse through Lotus Lantern

Tap music mode in Lotus Lantern and the footwells start dancing. A sensitive microphone in the controller listens to the cabin, so the car stereo, a phone on the dash speaker or the whole car singing along all drive the colour. Beats flash the lamps; quiet passages let them settle into a soft glow.

  • Steady: one colour, dimmed to taste, for everyday driving.
  • Fade: a slow crossfade through the spectrum for relaxed cruising.
  • Strobe: quick flashes for parking-lot parties, never while moving.
  • Music: colour that follows the rhythm through the built-in mic.
  • DIY: custom colour mixes saved in the app.
ELK-BLEDOM on the phone? A Bluetooth scan in the car may list that name. It is the lamp controller talking, so open Lotus Lantern and connect there, leaving the car's own Bluetooth free for the stereo. The pairing guide has iPhone and Android steps.

The app also offers timers and a memory that restores the last colour when the ignition comes back on. A voice-control feature lets the phone's microphone change the colour on a spoken word, handy when both hands belong on the wheel.

Keep the brightness modest while driving and save the strobes for when the car is parked. Rules on interior lighting differ from place to place, and a gentle footwell glow is the style least likely to distract anyone.

Mic placement shapes how lively the show looks. Tucked near a door speaker, the controller catches every kick drum; buried deep in the dash, it hears less and reacts more gently. Nudge the sensitivity in the app until the flicker feels right for the music you play most.

Among its siblings

Where it glows in the lineup

ELK-BLEDOM light models by kind, September 2026. Highlighted: QAUBEN Car Footwell Lighting Kit.

Wiring the DC line under the dash

This version of the kit connects by a DC wire rather than a cigarette-lighter plug, which means it joins the car's 12V wiring directly. The result is the cleanest install: no plug hogging the power socket, no lead trailing across the console. It does ask for a little more care, or a trip to an installer, than a plug-in kit.

  1. Pick a 12V source that suits the behaviour wanted: an ignition-switched circuit turns the lamps off with the engine, a permanent feed keeps them available.
  2. Use an add-a-fuse tap on a spare fuse slot rather than cutting into factory wiring.
  3. Connect the controller's positive to the switched feed and its negative to a clean bare-metal earth point.
  4. Run each 150cm lead along the underside of the dash to its footwell, tucked behind trim panels.
  5. Mount the lamps facing down and slightly rearward, then test every colour before closing the trim.

The 150cm leads reach from a central controller to both sides of most cars, from small hatchbacks to family SUVs. Cable ties along existing looms keep them clear of pedals, steering linkages and seat runners.

  • Keep leads away from the pedals and anything that moves.
  • Park the controller near a speaker grille so the mic catches the beat.
  • Disconnect the battery before tapping into the fuse box, if unsure.

QAUBEN sells the same lamps with other power options, including a lighter plug and USB, but the version here is the DC wire kit. For a plug-in approach, look at the fibre-optic and acrylic kits in the family.

A permanent feed has one catch: a controller left listening all night draws a trickle from the battery. For a car parked for weeks between drives, the ignition-switched circuit is the safer home, and the memory still brings the colour back at the next start.

Other moods

Three more ways to glow

Bold acrylic bars2 Jushope Acrylic Car Interior Lights
Jushope Acrylic Car Interior Lights
Jushope's acrylic interior lights chase colours along the dash and doors, run from Magic Lantern.
  • Runs on the Magic Lantern app
  • Pulses to music from its own mic
  • Several colours at once, chasing effects
See the glow
Two lines of chasing colour3 YM E-Bright RGBIC Car Interior Lights
YM E-Bright RGBIC Car Interior Lights
YM E-Bright's RGBIC interior kit adds two lines with music sync, an app and a remote.
  • Runs on the Magic Lantern app
  • Pulses to music from its own mic
  • Several colours at once, chasing effects
See the glow

QAUBEN's footwell pair beside fibre and acrylic kits

Footwell lamps are the most subtle car lighting in the family. They light the floor, not the dash, so the cabin gains atmosphere without lines of colour on show. Kits that trace the dash and doors with fibre or acrylic bars go bolder, while underglow moves the show outside the car entirely.

KitWhere it glowsLook
QAUBEN footwell, 2 lampsFront footwellsSoft pools of colour on the floor
QAUBEN fibre optic, 5mDash, doors, consoleThin lines of colour along trim
Jushope acrylicDash and doorsGlowing bars with chasing colour
Xprite underglowUnder the carA halo on the road

Before ordering, decide on these:

  • Install style: hard-wired and hidden here; plug-in kits suit leased cars.
  • Coverage: two footwells, or lines along the whole cabin.
  • Effects: one matched colour, or chasing rainbows on an RGBIC kit.
  • App: Lotus Lantern here; the app guide explains the rest of the family.

As a gift for a new driver, the footwell pair is a quiet upgrade that suits any car and never looks aftermarket. For someone who wants the cabin to feel like a club, the fibre and acrylic kits pair well with it, adding lines of colour higher up while these lamps fill in the floor.

Matching the colours across kits is simple when both run on Lotus Lantern, as the QAUBEN fibre kit does. One app, two controllers, and the floor and the dash can glow in the same shade for a finished, coordinated cabin.

Glow questions

Hook-up questions

How is the QAUBEN footwell kit powered?

This version connects by a DC wire to the car's 12V system, ideally through an add-a-fuse tap on a switched circuit.

Are the QAUBEN footwell lamps waterproof?

Yes. The lamps are sealed to IP68 and sit in aluminium housings, so wet shoes and spills are no problem.

Will the kit fit my car?

It is a universal kit with two 150cm leads, long enough to reach both front footwells in most cars.

Which app controls the QAUBEN footwell lights?

Lotus Lantern, over Bluetooth. The lamps are found by the app itself, with no pairing step in the phone's settings.