Top lights
Neon rope · 50ft · Lotus Lantern

SILFU RGB Neon Rope Lights

A 50ft run of soft, dot-free neon that bends into curves, words and outlines, washes a room in one of 16 million colours and flickers along with the party through its built-in microphone.

  • Length50ft
  • LEDs1,080
  • AppLotus Lantern over Bluetooth
  • WaterproofIP67 rope, controller not waterproof
  • Power24V adapter, 24W
  • Remote44-key
Lights up
  • Outlining a bed wall, gaming desk or ceiling edge in smooth neon
  • Bending the rope into a word, wave or shape
  • Long runs where a 24V supply keeps the far end bright
Pass on it for
  • Several colours at once: the rope glows one solid colour at a time
  • A tiny desk accent: 50ft is a lot of rope to hide
  • A fully submerged controller: only the rope is IP67
See the glow

50ft of neon that curves around the bedroom wall

SILFU's rope trades the bead-by-bead sparkle of a normal LED strip for a smooth, continuous line of colour. Its 1,080 LEDs sit inside a diffused PVC tube, roughly 21 to every foot, so the light blurs into one glowing stroke with no visible beads. Stretched along a headboard wall or a ceiling edge, it reads like shop-window neon without the glass or the buzzing transformer.

The rope is RGB, which means all 50ft share a single shade and shift in unison. Pick a deep violet for gaming, a candle-warm amber for reading, or let the app fade slowly through the spectrum while music plays. Mixing red, green and blue gives the 16 million shades on offer, and brightness dims low enough for a sleepy late-night glow.

Fifty feet goes further than it sounds. Some ways people split it up:

  • Two walls of a bedroom, following the line where wall meets ceiling.
  • A full outline of a desk setup plus a shape or word above the monitor.
  • A long balcony rail, with the controller tucked inside the door.
  • A zigzag or wave across one feature wall, bent by hand as the rope goes up.

Everything runs from one 24V adapter at 24W. The low voltage keeps the tube cool enough to touch, which matters when the rope runs along a bunk bed or at a child's height. A higher voltage also means less current in the wire, so the last metres of a long run hold their colour better than a 5V strip of the same length would.

Light specs

Every wire and watt

SpecValue
Length50ft (one run)
Light typeFlexible LED neon rope
Number of LEDs1,080
ColourRGB, 16 million colours, one solid colour at a time
AppLotus Lantern (iOS and Android)
ConnectionBluetooth
Remote44-key
Control methodsApp, remote and touch control
Sound reactionBuilt-in microphone on the controller
TimerScheduled on and off
Operating voltage24V low voltage
Power supply24V adapter, mains powered
Rated power24W
Water resistanceIP67 rope; controller not waterproof
MaterialPVC
CuttingCuttable to length
Weight1.21kg
Model numberBINBIN-NHRGB15M

Party mode on SILFU's mic and the 44-key remote

The controller carries its own microphone, and in music mode it listens to the room and snaps the neon to the beat. Bass drops punch the colour brighter, quieter passages let it breathe, and a rave playlist turns the whole wall into a pulse. The effect follows any sound source, whether that is a soundbar, a laptop or a guitar in the corner.

Three ways of steering the glow share the job:

  • Lotus Lantern app for colour picking, scenes, music sync and the timer.
  • 44-key remote for quick colour, brightness and speed changes from across the room.
  • Touch control on the controller for evenings when the phone and remote have both wandered off.

The timer switch is the quiet hero. Set the neon to fade in with a morning alarm or to switch off an hour after bedtime, and the rope stops being a party trick that someone forgets to turn off. Scenes saved in the app bring back a favourite colour in one tap.

The ELK-BLEDOM name on a phone belongs to the neon's controller, not a stray speaker. Open Lotus Lantern with Bluetooth switched on and let the app find it; the phone's Bluetooth settings can be ignored. The app guide explains each mode.

One phone at a time normally holds the Bluetooth connection, so a second person with the app may not see the light until the first one closes it. The remote sidesteps that at a party: anyone can grab it and change the mood without an app or a password.

Among its siblings

Where it glows in the lineup

ELK-BLEDOM light models by kind, September 2026. Highlighted: SILFU RGB Neon Rope Lights.

Bending SILFU rope into words and outlines

Neon rope earns its keep when it bends. Sketch the shape first on paper at full size, or mark it lightly on the wall with painter's tape, then count how much rope the design eats before cutting anything. Gentle curves hold better than sharp kinks, and each bend looks cleaner when the rope is warmed to room temperature first.

  1. Plan where the controller and the 24V adapter will sit, close to an outlet and out of the rain.
  2. Fix the start of the rope near the controller, then work along the design a short section at a time.
  3. Use mounting clips or a channel at every change of direction so curves do not spring back.
  4. Cut any excess only at the marked cut points, and test the colours before the last clip goes on.

Cutting shortens the run for good. The piece beyond the cut stays dark unless it gets its own connector and power, so measure twice and cut once. Spare rope can also stay coiled out of sight behind furniture rather than being trimmed. For a child's room, simple shapes read best from bed: a cloud, a lightning bolt or a single initial.

The IP67 rating covers the rope itself: sealed against dust and fine if briefly submerged. That makes a covered porch, a bathroom mirror frame or a balcony rail fair game. The controller is not waterproof, though, and neither is a standard wall adapter, so both belong indoors or in a sealed box.

  • Indoor bedrooms, game rooms and kitchens: no extra care needed.
  • Covered outdoor spots: keep the controller dry and the plug off the ground.
  • Open sky and puddles: seal the cut end and shelter every electrical joint.
Other moods

Three more ways to glow

Why SILFU's one-colour neon suits a calm room

Single-colour neon has a mood of its own. A whole wall in one shade feels deliberate, almost architectural, where a chasing rainbow feels like a party that never ends. SILFU's rope leans into that calmer style while still flashing to the music when the night calls for it.

Neighbouring ropes for other rooms:

Choose SILFU when the job needs one long, even line and the room is mostly indoors. Its 1,080 LEDs, 24V supply and 44-key remote make it a well-equipped all-rounder for bedrooms and game rooms. Pick something shorter if the design fits on one wall, and something longer if the whole garden fence is in the plan.

Streamers like it for a practical reason too. A solid wash of one colour lights a face evenly on camera, where a busy chase can flicker across the frame. Match the neon to an overlay or a team colour, save it as a scene, and the backdrop looks the same every broadcast.

Before ordering, weigh three things: how far the outlet sits from where the rope starts, where the controller will stay out of the wet, and whether the design needs one colour at a time or a multi-colour chase. That last point decides between plain RGB neon like this one and an addressable RGBIC strip. Setting up for the first time? The pairing walkthrough gets the phone and the rope talking.

Glow questions

Hook-up questions

Can SILFU neon rope go outdoors?

The rope is rated IP67, so it handles rain and even brief immersion. The controller and adapter are not waterproof, so keep them indoors or in a sealed box.

Can I cut the 50ft rope shorter?

Yes, at the marked cut points. The cut-off piece stays dark unless it gets its own connector and power, so measure the design first.

Does it show more than one colour at once?

No. As an RGB rope, the full length always matches, one solid shade moving to the next.

Which app runs it?

Lotus Lantern. The controller announces itself as ELK-BLEDOM, but the link is made inside the app.